By . Clamp. At Friday, August 24th 2018, 23:04:31 PM.
The brand - There are numerous brands in the market and fact is that some names are trusted in the carpentry field than others. When choosing, settle on a reputable brand to enjoy good quality and durability.
To use a pipe clamp, it is important to use proper measurements. First, take a measurement of the wood pieces that are to be glued together. Then, either find a pipe that is already the right size or cut a section of pipe to match this measurement, with about an extra foot. Metal or PVC pipe can be used because both are durable, you just need to ensure that one end of the pipe is threaded. Attach the static clamp to the non-threaded side and secure it in place, then attached the tightening clamp to the threaded end of the pipe. Size up the wood and make sure it is connected in the way you need to it to co me out in the end, and then slowly tighten the clamp down the threaded section until it is held together firmly. If you are working with multiple pipe clamps, it can be easier to tighten one side a little and then the other side a little more, incrementally increasing the hold on the wood until there is balanced pressure.
Once the wood is clamped into place, spread wood glue along the seal where the wood will need to connect at a joint. Spread the glue with your finger or a piece of card stock to ensure there is an even distribution and the glue won't cause warping while it cures. Follow the instructions for the glue about curing time, and then you can release the pipe clamps. If using more than one clamp, it is best to incrementally loosen pressure on each clamp as opposed to removing them one by one. If the curing process went smoothly and pressure was distributed correctly, the wood should be firmly connected.